Are all screws in the cooling tower free of debris, and whether the fan and the sprinkler system roll smoothly? Check whether the power supply and motor voltage are the same, and whether the belt assembly is correct. Open the water supply valve to fully fill the water basin and water pipe, and the water level is 25mm below the full water pipe. When starting, turn on the fan before the water pump, check the wind direction and air volume, and adjust it in time until it meets the requirements.

According to the foundation map provided by the manufacturer, first of all, measure whether the foundation is pre-buried correctly and whether the foundation is horizontally consolidated. Otherwise, the corresponding treatment or suspension device must be performed. After the foundation foundation verification is completed, the lower iron frame is combined with the lower iron frame and the number of the iron parts. The legs of the non-iron frame may be installed in the center of the embedded steel plate. Adjust the upper iron frame to make it as possible as possible. Located on the same level.

It should be installed on waterproof walls, high walls that can easily reflect the volume, and it should be installed on the roof or in a place with good air circulation. When two or more cooling towers are used together, pay attention to the tower distance. The device should not be in places with external walls or airtight on all sides, and the distance between the tower body and the external wall should be paid attention to. The device should be protected from sooty and dusty places, and the film should not be blocked.

What types of cooling towers can be divided into:

1. Divided into natural ventilation cooling tower, mechanical ventilation cooling tower and mixed ventilation cooling tower according to the ventilation mode.

2. According to the contact mode of hot water and air, there are wet cooling towers, dry cooling towers, and wet and dry cooling towers.

3. According to the moving direction of hot water and air, there are counter-flow cooling tower, cross-flow (communication) cooling tower and mixed-flow cooling tower.

4. According to the purpose, it is divided into general air-conditioning cooling tower, industrial cooling tower and high-temperature cooling tower.

5. According to the noise level, it is divided into ordinary cooling tower, low-noise cooling tower, ultra-low-noise cooling tower, and ultra-quiet cooling tower.

6. Others such as jet cooling tower, fanless cooling tower, hyperbolic cooling tower, etc.

7. According to the shape of FRP cooling tower, it is divided into round FRP cooling tower and square FRP cooling tower.